ZM LiveCD installed on HD. I need to add ssh to it.

ariel_ · Post by **ariel_** » Fri Jul 29, 2005 4:14 pm

I am new to Mandrake and linux in general. But I need to get to the ZM Box remotely. I would like to know how do I install and setup ssh and vnc to the xwindow of the system.

It's up and running fine. Also would you recommend more memory for 9 CAMs then 512mg of ram on a celeron 2.8?

Thank you for the replys.

jameswilson · Post by **jameswilson** » Fri Jul 29, 2005 5:52 pm

what capture rate and resolution you on on your 8 cams? I have run upto 16 on 512 with no probs and only about 15 meg paged. I think it matters what your buffers are set to really and your res and cap rate

ariel_ · Post by **ariel_** » Fri Jul 29, 2005 6:40 pm

jameswilson wrote:what capture rate and resolution you on on your 8 cams? I have run upto 16 on 512 with no probs and only about 15 meg paged. I think it matters what your buffers are set to really and your res and cap rate

320X240 max 7 fps. buffers. Hum I have not changed this from the default. What should I put there?

rdmelin · Post by **rdmelin** » Fri Jul 29, 2005 9:03 pm

ssh is installed and running by default.

vnc is installed. To config it see this thread:
http://www.zoneminder.com/forums/viewto ... hlight=vnc