PTZ Config

Forum for questions and support relating to 1.33.x development only.
Post Reply
Radiotwo
Posts: 3
Joined: Mon Dec 10, 2018 3:39 pm

PTZ Config

Post by Radiotwo » Mon Jan 07, 2019 7:48 pm

Hi I am trying to configure the Hikvision PTZ control in the control section in V1.33.x
I have found the section for the Hikvision but the bit I cannot find the information for:
Control device
Control Address
Could anyone help please?

Steve
Attachments
Screenshot-2019-1-7 ZM - Monitor - Monitor-5.png
Screenshot-2019-1-7 ZM - Monitor - Monitor-5.png (35.18 KiB) Viewed 2025 times

vincentstans
Posts: 1
Joined: Mon Jan 07, 2019 8:05 pm

Re: PTZ Config

Post by vincentstans » Mon Jan 07, 2019 11:38 pm

The HikVision.pm says the following

for me this file is found @

Code: Select all

/usr/share/perl5/ZoneMinder/Control/HikVision.pm
# ==========================================================================
#
# HiKVision ISAPI Control Protocol
#
# Set the following:
# ControlAddress: username:password@camera_webaddress:port
# ControlDevice: IP Camera Model
#
# ==========================================================================
Hope this helps you any further.

pennyzm
Posts: 11
Joined: Wed Oct 10, 2018 7:59 pm

Re: PTZ Config

Post by pennyzm » Fri Apr 26, 2019 12:36 pm

I am looking at getting some Hikvision PTZ cameras, were you able to get this working?
What hikvision model camera are you using?

Kind regards,
pennyzm

CancunManny
Posts: 3
Joined: Fri Dec 13, 2019 2:37 am

Re: PTZ Config

Post by CancunManny » Wed Dec 18, 2019 12:59 am

Post is a bit old, but in case people are wondering it seems some of the Hikvision cameras do work. I actually have an LaView camera, and by accident I found that there is a Hikvision one exactly the same, only thing that changes is the logo.

I set it up as a hikvision camera and got the pan and tilt to work, as well as the presets. My camera doesn't have zoom, auto focus, but if your hikvision camera has these options it seems they would work as well.

If you still interested let me know and I will post some instructions on how I got mine setup

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests