PTZ Config

Forum for questions and support relating to 1.33.x development only.
Post Reply
Posts: 3
Joined: Mon Dec 10, 2018 3:39 pm

PTZ Config

Post by Radiotwo » Mon Jan 07, 2019 7:48 pm

Hi I am trying to configure the Hikvision PTZ control in the control section in V1.33.x
I have found the section for the Hikvision but the bit I cannot find the information for:
Control device
Control Address
Could anyone help please?

Screenshot-2019-1-7 ZM - Monitor - Monitor-5.png
Screenshot-2019-1-7 ZM - Monitor - Monitor-5.png (35.18 KiB) Viewed 286 times

Posts: 1
Joined: Mon Jan 07, 2019 8:05 pm

Re: PTZ Config

Post by vincentstans » Mon Jan 07, 2019 11:38 pm

The says the following

for me this file is found @

Code: Select all

# ==========================================================================
# HiKVision ISAPI Control Protocol
# Set the following:
# ControlAddress: username:password@camera_webaddress:port
# ControlDevice: IP Camera Model
# ==========================================================================
Hope this helps you any further.

Post Reply

Who is online

Users browsing this forum: nhouari and 1 guest