Page 1 of 1

PTZ Config

Posted: Mon Jan 07, 2019 7:48 pm
by Radiotwo
Hi I am trying to configure the Hikvision PTZ control in the control section in V1.33.x
I have found the section for the Hikvision but the bit I cannot find the information for:
Control device
Control Address
Could anyone help please?

Steve

Re: PTZ Config

Posted: Mon Jan 07, 2019 11:38 pm
by vincentstans
The HikVision.pm says the following

for me this file is found @

Code: Select all

/usr/share/perl5/ZoneMinder/Control/HikVision.pm
# ==========================================================================
#
# HiKVision ISAPI Control Protocol
#
# Set the following:
# ControlAddress: username:password@camera_webaddress:port
# ControlDevice: IP Camera Model
#
# ==========================================================================
Hope this helps you any further.

Re: PTZ Config

Posted: Fri Apr 26, 2019 12:36 pm
by pennyzm
I am looking at getting some Hikvision PTZ cameras, were you able to get this working?
What hikvision model camera are you using?

Kind regards,
pennyzm