[SOLVED] Activate/deactivate function by commandline?

Forum for questions and support relating to the 1.26.x releases only.
Locked
roadster
Posts: 20
Joined: Thu Dec 26, 2013 4:15 pm

[SOLVED] Activate/deactivate function by commandline?

Post by roadster »

Can the function of a camera be de/activated by commandline?
I would like to turn off function, move to different position and then turn on function e.g. modect again.
Else while moving it generates an alarm that is unwanted...
Last edited by roadster on Fri Feb 07, 2014 5:10 pm, edited 1 time in total.
roadster
Posts: 20
Joined: Thu Dec 26, 2013 4:15 pm

Re: Activate/deactivate function by commandline?

Post by roadster »

OK, solution is near... ZMU can be invoked to inactivate the monitors, now just find something about the syntax :D
roadster
Posts: 20
Joined: Thu Dec 26, 2013 4:15 pm

Re: Activate/deactivate function by commandline?

Post by roadster »

OK, this is solved too... the wiki covered everything I wanted to know about zmu.
Now cameras pan without triggering any unnecessary alarms.
Locked