Run state settings

[Jamo]

Hi Everyone

I'm loving zoneminder. It's chewing up just about all my time at the moment as I tinker, configure, tweak and re-tweak the settings, leopard-crawl up to the house to see if I'm detected etc etc. It's great.

I have a question about run state settings. Forgive me if this is covered in a wiki somewhere and I've missed it. Basically, I understand that you can create new run states where you save the current monitor settings.... but can someone clarify what settings are and are not saved with these run states? Is it just the settings on the monitor or does it include the zone settings and the general config settings - eg. pixel threshold (zone setting) and alarm frames (general setting).

Ideally, I'd like to vary the sensitivity between night and day but that would include settings other than just those on the monitors.

many thanks
James