Features in 1.37

Current Development version likely to have breaking changes
Post Reply
User avatar
iconnor
Posts: 1988
Joined: Fri Oct 29, 2010 1:43 am
Location: Toronto
Contact:

Features in 1.37

Post by iconnor »

I should have made this at the start.. but here we go. I may miss a few, but they'll get added later.

What is in 1.37 that isn't in 1.36?

- Janus support for live viewing using h264
- Better zoom-in support -> this will likely get into 1.36 soon though
- Remove Function concept, replacing with Capturing, Analysing, Record options. Allows for Motion detection without recording. Allows for OnDemand capturing.
- Additional options for Decoding: Keyframes Only, On Demand, Ondemand+Keyframes
- Model, Manufacturer labelling in Monitors
- ffmpeg v4l support
- Support for executing a command on start/stop of event, removing the need for zmeventserver
- ONVIF/Amcrest event notification support: motion detection on the camera
- Cycle view merged into Watch view with improved UI
- FPS Control in watch view
- Option to do motion detection on the Y-channel, reducing cpu use
dotelpenguin
Posts: 2
Joined: Sun Jun 19, 2022 5:02 pm
Contact:

Re: Features in 1.37

Post by dotelpenguin »

- Remove Function concept, replacing with Capturing, Analysing, Record options. Allows for Motion detection without recording. Allows for OnDemand capturing.
- Additional options for Decoding: Keyframes Only, On Demand, Ondemand+Keyframes
-Option to do motion detection on the Y-channel, reducing cpu use

Wow this greatly reduced the load on my CPU's.

9 Cameras
2x 5mp (15 fps 15 keyframes)
7x 1080p (20 fps 10 keyframes)

Load Average 17-20 (yes I know this is bad, but not spending money on new hardware at moment)

After setting Decoding to Ondemand+keyframes and Y-Channel motion detection Load average is between 1.5 and 2.5.

Impressive change!

I noticed a "SourceSecondPath" appeared in the Source config. But Not sure what it does. Havn't found any documented references to it yet.
Post Reply