Apparently it seems that all HTTP/RTSP support was removed with v2 of the firmware
Is there any way to downgrade to 1.X? My camera already came with v2.
Dlink DCS-8000LH
-
- Posts: 5
- Joined: Wed May 16, 2007 11:19 am
Re: Dlink DCS-8000LH
Here are the settings working for a version 1.01.01
with h720 codec
[General]
Source: libvlc
[Source]
Source Path: http://USERNAME:PASSWORD@xxx.xxx.xxx.xxx/video/flv.cgi
Method: TCP
Colourspace: 24-bit
Width: 1280
Height: 720
with MJPEG
curl "http://USERNAME:PASSWORD@xxx.xxx.xxx.xx ... odec=MJPEG"
(if needed you can revert doing curl "http://USERNAME:PASSWORD@xxx.xxx.xxx.xx ... codec=H264" )
then
[General]
Source Type: remote
[Source]
Remote Protocol: HTTP
Remote Method: Simple
Remote Hostname: USERNAME:PASSWORD@xxx.xxx.xxx.xxx
Remote Host Port: 80
Remote Host Path: /video/mjpg.cgi
color: 24 bits
Width: 1280
Height: 720
with JPEG
[General]
Source Type: remote
[Source]
Remote Protocol: HTTP
Remote Method: Simple
Remote Hostname: USERNAME:PASSWORD@xxx.xxx.xxx.xxx
Remote Host Port: 80
Remote Host Path: /video/jpeg.cgi
color: 24 bits
Width: 640
Height: 360
Currently I am still unable to access my camera with firmware 2.00.05 . It seems that password is randomly generated on upgrade, unless someone can confirm the old one set when still on version 1.01.01 remains.
with h720 codec
[General]
Source: libvlc
[Source]
Source Path: http://USERNAME:PASSWORD@xxx.xxx.xxx.xxx/video/flv.cgi
Method: TCP
Colourspace: 24-bit
Width: 1280
Height: 720
with MJPEG
curl "http://USERNAME:PASSWORD@xxx.xxx.xxx.xx ... odec=MJPEG"
(if needed you can revert doing curl "http://USERNAME:PASSWORD@xxx.xxx.xxx.xx ... codec=H264" )
then
[General]
Source Type: remote
[Source]
Remote Protocol: HTTP
Remote Method: Simple
Remote Hostname: USERNAME:PASSWORD@xxx.xxx.xxx.xxx
Remote Host Port: 80
Remote Host Path: /video/mjpg.cgi
color: 24 bits
Width: 1280
Height: 720
with JPEG
[General]
Source Type: remote
[Source]
Remote Protocol: HTTP
Remote Method: Simple
Remote Hostname: USERNAME:PASSWORD@xxx.xxx.xxx.xxx
Remote Host Port: 80
Remote Host Path: /video/jpeg.cgi
color: 24 bits
Width: 640
Height: 360
Currently I am still unable to access my camera with firmware 2.00.05 . It seems that password is randomly generated on upgrade, unless someone can confirm the old one set when still on version 1.01.01 remains.
Re: Dlink DCS-8000LH
Enabling the HTTP support is still possible in the v2 firmwares.
EDIT: Got RTSP working too. It is actualy even simpler than HTTP, since it can be permanently enabled by Bluetooth without any modifications to the firmware at all.
Please see https://github.com/bmork/defogger for a guide on how to enable RTSP, lighttpd and telnetd. The guide includes a Bluetooth tool making the mydlink app and clound unnecessary even for initial setup.
Re: Dlink DCS-8000LH
Could someone walk me thru the steps?