Hi.
I stumbled on a new issue, where ZM simply skips large chunks of time (up to 10 minutes), in the recordings.
I'm using the following zone settings, based on Best, high sensitivity, tuned for increased detection:
Min/Max Pixel Threshold (0-255) 20
Filter Width/Height (pixels) 3 3
Zone Area 100
Min/Max Alarmed Area 4 0
Min/Max Filtered Area 3 0
Min/Max Blob Area 2
Min/Max Blobs 1
There is nothing in the logs - no buffer overrides, no ZMC or ZMA restarts, or anything else.
I'm using version 1.22.2.
Any idea if there any motion detection bugs found and fixed since this version?
ZM skips large chunks of recordings
-
- Posts: 5111
- Joined: Wed Jun 08, 2005 8:07 pm
- Location: Midlands UK
afaik there has been no significant chnages.
but you might want to increase the sens a bit.
but you might want to increase the sens a bit.
James Wilson
Disclaimer: The above is pure theory and may work on a good day with the wind behind it. etc etc.
http://www.securitywarehouse.co.uk
Disclaimer: The above is pure theory and may work on a good day with the wind behind it. etc etc.
http://www.securitywarehouse.co.uk