Hi,
I have several IP cameras which I need to manage in different profiles. I would like to change the monitor function (monitor->modec->record...etc) of each camera based on time and some other rulles.
In the forum it is suggested to set the Run-State but this will restart all cameras per each monitor change; and not just the desired one.
My basic question is:
is it possible to control each monitor function seperatly?
Regards
Changing monitor's function by time
- zoneminder
- Site Admin
- Posts: 5215
- Joined: Wed Jul 09, 2003 2:07 pm
- Location: Bristol, UK
- Contact:
You can individually restart monitors with zmdc.pl. So you can change the function in the DB and then do something like
You will only need to restart zma provided you are not going from a monitor being completely off to some other mode, in which case you should restart zmc first. Just changing from record to modect etc is fine and only needs zma.
Code: Select all
zmdc.pl restart zma -m 1
Phil