Analysis doesn't work with passthrough?
Posted: Tue Jun 22, 2021 5:53 am
Hi,
I'm a longtime zm user, but had been stuck on an old version (1.28?) for a while. I recently upgraded and started fiddling with the source settings.
I've historically used only JPEG storage, but I would like to move to using the video writer only, to reduce I/O load. However, the "auto" setting doesn't seem to work. I get an error from vjs when trying to view an event. Passthrough seems to work fine for recording and viewing, including viewing while recording (which the wiki suggests isn't supported) but no analysis seems to be done when in modect mode. Also, when I go to configure zones, I get an error and no image shows up.
Is this something that should work?
I'm using Foscam FI9900EP and Foscam FI9853EP cameras.
FFMpeg with RTSP, no hardware decode
I'm a longtime zm user, but had been stuck on an old version (1.28?) for a while. I recently upgraded and started fiddling with the source settings.
I've historically used only JPEG storage, but I would like to move to using the video writer only, to reduce I/O load. However, the "auto" setting doesn't seem to work. I get an error from vjs when trying to view an event. Passthrough seems to work fine for recording and viewing, including viewing while recording (which the wiki suggests isn't supported) but no analysis seems to be done when in modect mode. Also, when I go to configure zones, I get an error and no image shows up.
Is this something that should work?
I'm using Foscam FI9900EP and Foscam FI9853EP cameras.
FFMpeg with RTSP, no hardware decode