PurgeWhenFull multiple storage areas

Forum for questions and support relating to the 1.34.x releases only.
Post Reply
lightguy48
Posts: 39
Joined: Sun Nov 15, 2015 7:19 pm

PurgeWhenFull multiple storage areas

Post by lightguy48 » Thu Jul 22, 2021 1:42 am

I searched the forum and only found one post from about 3 years ago and I didn't see any discussion after the initial question. I now have a similar configuration where I have a server with three drives to break up my Mocord storage for my cameras.

Is the best method to handle multiple storage areas to create one Filter for each storage area? i.e. filter 1 is storage >95 percent and storage equals drive1, and repeat an additional Filter for storage 2 and 3? Or is there another method where you could do storage 1 or storage 2 or storage 3?

Also, what is 'secondary storage area' ? Does that filter option have a use in this application?

Thanks!

burger
Posts: 276
Joined: Mon May 11, 2020 4:32 pm

Re: PurgeWhenFull multiple storage areas

Post by burger » Thu Jul 22, 2021 1:54 am

Separate filter for each storage area, yes. See:
https://wiki.zoneminder.com/Using_a_ded ... Hard_Drive
fastest way to test streams:
ffmpeg -i rtsp://<ipaddress>:554/path output.mp4
from terminal, and run through paths on ispydb or in zm hcl

If you are new to security software, read this:
https://wiki.zoneminder.com/Dummies_Guide

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests