Page 1 of 1

Zones settings pls help

Posted: Wed Mar 13, 2019 1:05 pm
by mcll
Hi,

I have the following setting for this zone (see below). Now it is recording all of the pedestrian and passing cars, motors, etc which can be seen on this zone window. But i want to record ONLY when someone stopps at the door, not every motion. Is that possible? If yes, what settings should i choose. Unfortunatelly the settings are not clear for me.

So the settings now:
ZM-01.JPG
ZM-01.JPG (40.75 KiB) Viewed 2580 times
Here the zone, which is not so big:
ZM-02.JPG
ZM-02.JPG (21.42 KiB) Viewed 2580 times
And the frame sizes:
ZM-03.JPG
ZM-03.JPG (18.37 KiB) Viewed 2580 times

Re: Zones settings pls help

Posted: Thu Mar 14, 2019 12:23 am
by DVB Hardware
Based on the picture, the person walking is that a
1.Sidewalk ?
2.Parking lane ?
3.Driving lane ?

Make the trigger zone narrower till you don't get false alarms

Re: Zones settings pls help

Posted: Thu Mar 14, 2019 3:25 pm
by mcll
Thanks, tried to reduce the triggering zone, but no change. Also lovered the settings to Fast, Low Sensitivity, no change. :(
This is a small street, with walkers, cars, etc.

Here a car is passing by )was not slow...)
ZM-12.JPG
ZM-12.JPG (163.61 KiB) Viewed 2552 times
The new trigger zone:
ZM-13.JPG
ZM-13.JPG (18.71 KiB) Viewed 2552 times
And the new settings:
ZM-14.JPG
ZM-14.JPG (41.82 KiB) Viewed 2552 times
I have another zone, a bigger one, for the area in my garden, but also tried to extend the triggering zone to a little bit higher than the door, but was not ok. Without the second zone (which should only record when someone stops before the door) the recording only starts when someone is in my garden.