Zones settings pls help

[mcll]

Hi,

I have the following setting for this zone (see below). Now it is recording all of the pedestrian and passing cars, motors, etc which can be seen on this zone window. But i want to record ONLY when someone stopps at the door, not every motion. Is that possible? If yes, what settings should i choose. Unfortunatelly the settings are not clear for me.

So the settings now:

ZM-01.JPG (40.75 KiB) Viewed 2601 times

Here the zone, which is not so big:

ZM-02.JPG (21.42 KiB) Viewed 2601 times

And the frame sizes:

ZM-03.JPG (18.37 KiB) Viewed 2601 times

[DVB Hardware]

Based on the picture, the person walking is that a
1.Sidewalk ?
2.Parking lane ?
3.Driving lane ?

Make the trigger zone narrower till you don't get false alarms

[mcll]

Thanks, tried to reduce the triggering zone, but no change. Also lovered the settings to Fast, Low Sensitivity, no change.
This is a small street, with walkers, cars, etc.

Here a car is passing by )was not slow...)

ZM-12.JPG (163.61 KiB) Viewed 2573 times

The new trigger zone:

ZM-13.JPG (18.71 KiB) Viewed 2573 times

And the new settings:

ZM-14.JPG (41.82 KiB) Viewed 2573 times

I have another zone, a bigger one, for the area in my garden, but also tried to extend the triggering zone to a little bit higher than the door, but was not ok. Without the second zone (which should only record when someone stops before the door) the recording only starts when someone is in my garden.