Blue screen after reboot/reset of RTSP/ONVIF camera

Forum for questions and support relating to the 1.29.x releases only.
Locked
mrbill
Posts: 20
Joined: Thu Jan 19, 2017 7:13 am

Blue screen after reboot/reset of RTSP/ONVIF camera

Post by mrbill »

I installed a new RTSP camera - a wanscam hw0029. Works fine - works great, except after I reboot it, sometimes ZM doesn't seem to re-connect to the stream and gives a blue screen. I can resolve this quite easily by disabling and re-enabling the camera under the function menu and un-checking 'enabled' (then save), then checking it agian, and saving.

Is this a known issue in 1.29 and perhaps resolved in later versions? I loath to upgrade because of all the setup etc, and what I have now 'just works' fine.
Locked