Need an assist here.
I have gone through the forums and seen other post's that guys are able to use this camera without any issues. I can view the camera via VLC @ the following address.
rtsp://192.168.1.113:554/11 (Source Stream)
rtsp://192.168.1.113:554/12 (Sub Stream)
However I have tried adding the camera as remote, ffmpeg etc and can not get it to pull a stream.
For Remote I am trying the following.
Remote Protocol : RTSP
Remote Method : RTP / RTSP
Remote Host Name : 192.168.1.113
Remote Host Port : 554
Remote Target Path : /11
* Tried this as /11, /12, 11, 12.
SV3C - Zoneminder (Help)
Re: SV3C - Zoneminder (Help)
Hard to say without logs. Look at them. Paste them here.
Maybe try the ONVIF detect method.
Maybe you need to add username/password?
Maybe try the ONVIF detect method.
Maybe you need to add username/password?
Re: SV3C - Zoneminder (Help)
Thanks for the hint on the username / password.
The camera is setup to where they do not use a username / password. Looking through the forums I found someone with a similar issue where the following was enabled which would prevent the camera's feed from pulling.
Options > System > AUTH_RELAY
Changed this setting to "none" and poof the camera is working fine now.
Thanks for the nugget that got me looking in the right direction.
The camera is setup to where they do not use a username / password. Looking through the forums I found someone with a similar issue where the following was enabled which would prevent the camera's feed from pulling.
Options > System > AUTH_RELAY
Changed this setting to "none" and poof the camera is working fine now.
Thanks for the nugget that got me looking in the right direction.
Re: SV3C - Zoneminder (Help)
Thanks so much!! I spent days banging my head against the wall over this exact problem. Made the change you suggested you found
Options > System > AUTH_RELAY set to none
And it started working. Thanks again to you and this Forum
Options > System > AUTH_RELAY set to none
And it started working. Thanks again to you and this Forum