Config for IC-3010

kerlo · Post by **kerlo** » Fri Apr 10, 2009 11:15 am

Hello,
I've you have an edimax IC-3010

Can you give the config for this cam

( i've one but i don't find the config )

many thanks for your help

Post by **cordel** » Fri Apr 10, 2009 11:36 am

Might give http://ip/file.jpg a try.Else maybe:

http://ip.address/snapshot.jpg
http://ip.address/snapshot.cgi

Also have a look at: http://ic1500.wikispaces.com/
Though I would have thought it to be more useful on either our wiki or Motions, but okay.

Most of this is from this thread:
http://www.zoneminder.com/forums/viewto ... x&start=15

kerlo · Post by **kerlo** » Fri Apr 10, 2009 4:26 pm

Thanks

I've image in Web browser
( Firefox on linux no activeX )
with
http://camera-ip/snapshot.jpg

but in zoneminder it's a problem of shared memory
not the access of webcam in fact

Many thanks

i'm looking to Orbit AF Webcam configuration if anyone

Mny thanks again

kerlo · Post by **kerlo** » Sat Apr 25, 2009 6:23 pm

Again
I've installed Zm 1.24

and want to do working my cam with this version in rtsp

i can open cam in totem
with this addresse
rtsp://192.168.0.3:554/ipcam.sdp

but i try many differents settings but i don't have any image

If someone i've found the good configuration many thanks

kerlo · Post by **kerlo** » Wed May 13, 2009 7:57 pm

No suggestion of using my cam with rtsp ?

many thanks

UnknownX · Post by **UnknownX** » Thu Sep 10, 2009 5:37 pm

Kerlo - or anyone else -,

do you got a solution for the rtsp stream of such camera ?

many thanks ...

kerlo · Post by **kerlo** » Fri Sep 11, 2009 6:54 am

Sorry i've no more news for this camera

sef1976 · Post by **sef1976** » Fri Sep 11, 2009 7:07 am

share it on inet
and i see configuration

UnknownX · Post by **UnknownX** » Fri Sep 11, 2009 10:54 pm

hi@ll,

during the last hours i've set up a new and clean lenny and installed all parts as described in the the documentation of ubuntu step-by-step. Now I have a good stream with 320x240 a average of 20-25 fps which i find very good result with zm on a virtual machine

nevertheless there are new questions:
first of all: is it possible to get a mpeg4 stream from the cam to zm ? I have tried the versions of snapshot.jpg/cgi and also the rtsp connection which all worked.
if it is so - until this time i know some commercial products which allow to do a motion detection with a stream of a low bandwidth/resolution and record a high quality stream only if a motion is detected.
with this feature (where i don't know if it possible in zm to combine to streams this way) the cpu usage could be hold very low.

so there are two questions:
1.) is it possible to receive a mpeg4 stream (cause of the firmware of the cam you can only set the resolution either for mjpeg or mpeg4 and as far as i know it is not possible to receive e.g. two mjpeg streams with different resolutions/quality at the same time) ?

2.) is it possible to do motion detection an a "low bandwidth" stream an do the record on another source with high quality ?

many thanks for your answers !

regards
stefan