Linked Monitors - Both cam must record?

[xefil]

Hello!
I'm testing the possibillità to use the LOW Stream of my cam and then, in case of motion, register on the high resolution stream.
Until here all ok, I've this settings:

LOW-CAM: Modect
HIGH-CAM: Nodect - Linked to LOW-CAM

So, if something is detected on the LOW-CAM, the HIGH cam gets triggered and starts to record.

BTW I've noticed that LOG-CAM stream is recorded as well, so I have twice the same stream.
It's possible to register ONLY on the HIGH-CAM?

Then, it's possible to increare the pre- and post- seconds to have more registered time? (this seems more dificult due it's trivggered from another cam AFAYK).

Thanks!

Simon

[xefil]

Any help?

In addition, I've noticed that on my two ESCAM G02 (http://www.escam.cn/product/showproduct.php?id=58) the test to use double streams linked to register doesn't work well.
Cold it be possible due the camera model?

Thanks,

Simon

[iconnor]

ON the low res camera Monitor->Storage tab, set it to not store jpegs and nothing for Video Writer. db events will still be created, but files won't be stored on disk.

[xefil]

Thanks @iconnor for the help. Modify applied, I'll check the results.

Based on your experience, do you have ideas about the problem on the double stream on the cam?

Thanks, Simon

[iconnor]

Could be. I don't have any experience with that cam.

However I have seen lots of cams that can't handle multiple streams at the same time. YMMV

[xefil]

Okie, thanks for the help!
Maybe you could then suggest something good?

viewtopic.php?f=10&t=29040

Thanks for all!

Simon