new motion during post alarm frames (Modect mode)

Forum for questions and support relating to the 1.32.x releases only.
Post Reply
flyingpiglet
Posts: 3
Joined: Mon Jun 10, 2019 1:20 pm

new motion during post alarm frames (Modect mode)

Post by flyingpiglet » Sun Jun 16, 2019 10:23 am

I set post alarm buffers so that ZM captures about 10 seconds after alarm. The question is - what should happen if a motion occurs during post alarm period? I see it captures post alarm buffers and if another motion occurs close to the end of this period, no new alarm registered. The motion is just captured until the remaining post alarm frames are over and stops with them.

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests