Linked monitors not working

Forum for questions and support relating to the 1.32.x releases only.
Post Reply
Posts: 21
Joined: Sun Jun 26, 2016 12:39 pm
Location: Canada

Linked monitors not working

Post by Avro125 » Sun Apr 21, 2019 1:46 am

Upgraded my system a little while ago to 1.32.3.

I've noticed since then that my linked monitors will randomly stop recording. Restarting ZM from the console will restore the functionality.

I have a handful of cameras, most of which supply a low-def and hi-def stream. ZM is set to Modect on the low-def stream (low res, low fps) and if motion is detected, the linked monitor (high res, higher fps) which is set to Nodect but linked to the low-res should record.

I haven't nailed down a time-frame yet as to how long it works as intended before it stops. My system is for home use and it normally just runs in the background and I only look at it if I need to review some video.

I previously ran 1.30.4 and had no problems. Anyone else experiencing this issue? If so, have you found a solution?

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests