Zoneminder 1.25X,Wanscam M-Jpeg issues

[metallica1973]

I have Zoneminder 1.25X running on Debian Wheezy and have installed these cameras as per:
http://www.zoneminder.com/wiki/index.ph ... R4020A2_PT
I can see video,my zones are set for motion detection and etc. Below are the specs of the 2 cameras that I am using:
http://www.ebay.com/itm/330876527266?ss ... 1497.l2649
The issues that I am having is when I look at what has been recorded, The videos work but I can see blue screens which I think are disconnects based on the logs:

Code: Select all

Linked: camera1Signal: Lost, Reacquired

Code: Select all

Linked: camera2Signal: Lost, Reacquired

Another thing that is happening is that in my logs, the errors below are overwhelming my logs :

Code: Select all

 Corrupt JPEG data: 1 extraneous bytes before marker 0xd9

which from what I found on the net as issues with the code in which I can recompile zoneminder but will only take away the error out of the logs and am not confident that it will fix my camera disconnects or at least I think. I have tried this wired and wireless for it makes no difference. Any ideas?

[bb99]

Try removing the Maximum FPS and Alarm Maximum FPS entries on source::general tab. Just leave them blank and throttle fps at the camera.

[metallica1973]

thanks for the reply. Been there done that. These cameras have minimal configuration options via the guil. The only option that I though was useful was the baudrate area in which I played with all the option withour success. I emailed the company to see if they have heard of this issue and if there are any firmware updates that I could install. Hopefully they will have some decent feedback, though I dont expect much. This apparently is the fix:
http://www-personal.umd.umich.edu/~denn ... tjpeg.html