OS: CentOS 6 X64.
Everything seems to be good at this point but when motion is detected, the cameras go into the Alarm state.
After movement is over, or atleast that I can tell, the state still sits in Alarm.
How do I fix this?
Never Leaves Alarm State
-
MichaelTiemann
- Posts: 18
- Joined: Wed Apr 20, 2011 1:04 am
Re: Never Leaves Alarm State
I'd like to know too! I am using Axis cameras to do the motion detection, with ZM monitors in Nodect mode. I have seen million-frame videos captured before the alarm stops. I'd like to set a limit somewhere, but don't know where to do it.
-
dogmeat206
- Posts: 51
- Joined: Tue Oct 11, 2011 10:15 pm
Re: Never Leaves Alarm State
Again, another issue fixed by another admin here. When I asked him about it, he said he messed with the frames for the alarms as well as duration. I guess its set for 600 Seconds? Ive got both our axis cameras set to Modect