Upgrading - trying to - not working - semi-solved

Forum for questions and support relating to the 1.24.x releases only.
Locked
liderbug
Posts: 125
Joined: Wed Dec 19, 2007 4:46 pm

Upgrading - trying to - not working - semi-solved

Post by liderbug »

... never rains but it pours... First I lose (colors wonkie) my Axis 206W. So I reconfigured and moved my Axis 210, started over with v1.24.2. Only thing is now ZM image is blank/black, timestamp is 1969 and Source IP shows red. OK, time to upgrade to 1.26, I downloaded and ran cmake:

-- Checking for perl module Sys::Mmap
-- Checking for perl module Sys::Mmap - failed
-- Could NOT find PerlModules (missing: PERLMODULES_SYS_MMAP_MODULE)
CMake Error at CMakeLists.txt:403 (message):
Not all required perl modules were found on your system

I've check the code and it looks like I've got every thing cmake is looking for and if I "yum install" I get "already installed, nothing to do". Suggestions?

Thanks.
Chuck
-----------------------------
OK - next day, learned that if the camera outputs a stream that is 704x480 then the configuration must say 704x480. Not 640x480, not blank, not... 704x480 - <sigh>

I love computers, I love computers, I love computers, I love computers, I love computers, I love cI love computers, omputers, I love computers, I love computers, I love computers, I love computers,
<sometimes...>

Now as to the upgrading - @#$!#!$@!#
Locked