ZoneMinder Forums

Ive been with zm for a long time and I have never successfully built from source. That's my limitation not the codes. However I have built the betas using the puppy module one of the main men provide with great success. Before that I was using apt and Ubuntu to do it for me. Id say the build went wr...

have you updated the rest correctly, or are you thinking this command will update the lot?

should be ok at 320 res. you are setting the cam to that res as well as zm? 640x480 in colour will often be too much for normal shared mem setups

Very interesting. Do you have some images to share this picam grabs? Also whats it like in low light?

could be a shared mem issue, what res are you trying to run at

Am i missing how to use / install this skin? Also screen shots would be nice.

Imo cheap ip cameras should be avoided. All the ones ive ever tested have failed to be reliable

As long as your drives can take the througput

As above issues are usually disk io based. I have got around this in the past with raid 0 arrays

WHat chipset is on the main board. As above id try running with only 1 card to start with. I have had loads of issue with non intel mobos

drose its not there its in config iirc. idle/alarm/time.

Id agree it could be a db issue and would advise running a mysqlcheck to be sure. Have you had a powerdown?

I would suggest your segment end setting is set to idle? if so it was in alarm for a long period. Set to time instead.

As above id be amazed if an axis camera wasnt compatible. Just be careful with the maxfps string. If its not supported in the firmware then it may cause the camera to provide no image. Remove that from the default axis string and you should be fine. to test start with jpeg and work up from there

Were you using a different stream from the camera before. ispy uses the aforge .net library for image grabbing. Which is very good. But there may be more bandwidth efficient ways of you getting your stream.

As a side note its wonderful news that zm is being taken forward. I for one am very pleased. Thankyou